How To Install A Kitchen Sink Faucet

How To Install A Kitchen Sink Faucet. Take stock of the sink and mounting holes. Place the rubber or plastic gasket, or trim ring, over the faucet holes in the sink and set. Turn the water supply back on at the valves, and check for any leaks in the new tubes and fixtures.

How to Install a Kitchen Faucet Home. Made. Interest.
How to Install a Kitchen Faucet Home. Made. Interest. from www.homemadeinterest.com

Attaching the faucet to the sink is pretty easy. Set the sink into the opening in the countertop.

Next, You Will Feed The Hoses Through The Rubber.


Do not over tighten plastic nuts. Set the sink upside down on a padded sawhorse or counter. Disconnect the supply lines from the faucet. This will create a watertight seal and.

Position The Faucet In The Holes.


Unscrew the faucet aerator, open the hot side of the faucet and let the water run for a minute to flush debris out of the water line. Place the rubber or plastic gasket, or trim ring, over the faucet holes in the sink and set. Measure the inside width of the countertop where the sink will be installed. Tighten up the hold down nuts under the sink with pliers or a basin wrench.

The Valves Are Typically Under The Sink.


Turn off the hot water and repeat with the cold water. To mount the new faucet, it will first need to be anchored with putty. Use a basin wrench if you can’t reach the connections with your hands. After installing the system, hook up the water, and turn the water back on, run cold water through it for five minutes.

You Don’t Need To Take The Sink Back To Your Shop To Do This, Either.


Set the sink into the opening in the countertop. Mount the faucet on your sink, and tighten the hold down nuts using pliers or a basin. If necessary, remove the old faucet. Turn off the sink’s water supply.

Comments

Popular posts from this blog

Single Handle Kitchen Faucet Repair

Nickel Kitchen Faucet

Old Moen Kitchen Faucet